Verona L6-2.5L (2005)
10. Remove the return line and pressure line from the vehicle.
Installation
1. Route the pressure line from the power steering pump to the power steering gear.
2. Raise and suitably support the vehicle.
3. Route the return line from the fluid reservoir to the power steering gear.
4. Install the return securing bracket bolts near the radiator.
Tighten: Tighten the return line securing bracket bolt to 8 Nm (6 ft. lbs.).
5. Install the return line bracket securing bolts to the center member.
Tighten: Tighten the return line bracket securing bolts to the center crossmember to 8 Nm (6 ft. lbs.).
6. Connect the return line to the power steering gear outlet.
Tighten: Tighten the return line fitting to 28 Nm (21 ft. lbs.).