Verona L6-2.5L (2005)
8. Remove the control arm bracket from the control arm by removing the nut.
Installation
CAUTION: The weight of the vehicle must be supported by the control arms before the stabilizer link-to-control arm nuts or the stabilizer
shaft-to-stabilizer link nuts are tightened. This can be done by lowering the vehicle onto jack stands under the control arms have been installed.
Tighten: Tighten the control arm bracket nut to 110 Nm (81 ft. lbs.).
1. Install the control arm bracket nut.
2. Install the control arm bracket bolts and control arm bolt.
Tighten: Tighten the control arm bracket bolts to 90 Nm (66 ft. lbs.) and control arm bolt to 180 Nm (133 ft. lbs.).
3. Install the stabilizer link.
