Verona L6-2.5L (2005)
1. Install the centermember assembly and bolts.
Tighten: Tighten the centermember bolts to 90 Nm (66 ft. lbs.).
2. Install the centermember front damping block bolt and rear damping block bolt.
Tighten: Tighten the centermember front damping block bolt and rear damping block bolt to 80 Nm (59 ft. lbs.).
Crossmember Assembly Installation
Crossmember Assembly Installation
1. Install the control arm onto the crossmember assembly.
Tighten: Tighten the stabilizer bar bolts and nuts to 50 Nm (37 ft. lbs.).
2. Install the crossmember bolts-to-control arm, nuts-to-longitudinal and crossmember.
Tighten: Tighten the crossmember bolts-to-control arm and nuts-to-longitudinal to 150 Nm (110 ft. lbs.).
3. Install the out tie rod and control arm ball joint.
