Vitara 2WD V6-2.5L (2004)
5. If rear brake pressure is not within specification, adjust it by changing stay "A" position as follows.
Tightening torque LSPV stay bolt (a): 23 Nm (2.3 kgf-m, 17.0 ft. lbs.)
^
If rear brake pressure is higher than specification, move stay "A" to direction "a" and if it is lower, to direction "b".
^
Repeat steps 3-5 until rear brake pressure is within specification.
^
After adjustment, be sure to torque bolt to specification.
6. Disconnect brake pipe (2) (connecting between master cylinder secondary side and 4-way joint) from master cylinder (1).
Tighten plug (special tool (A)) to master cylinder. Depress brake pedal. If rear brake pressure is 95 - 100 kgf/cm2 when front brake pressure is
100 kgf/cm2, it means that front fail-safe system functions properly.
Rear brake pressure with applied by 10,000 kPa (100 kgf/cm2, 1,422 psi) on front brake 9,500 - 10,000 kPa (95 - 100 kgf/cm2, 1,350 - 1,422
psi)
Special tool
(A): 09956-02210
7. Upon completion of fluid pressure test, bleed brake system and perform brake test.