Vitara 2WD V6-2.5L (2004)
14. Using puller (1), disconnect knuckle (2) from ball stud (3).
15. Remove knuckle and wheel hub camp, while lowering jack.
16. Remove coil spring (1).
Installation
Reverse removal procedure to install coil spring.
NOTE:
^
Upper and lower diameters of coil spring are different.
^
Bring larger diameter end at bottom and set its open end in place on spring seat (1).
^
Be sure to use specified torque for tightening each fastener.
^
As for ball stud nut, be sure to insert split pin and bend it after tightening it.
^
Tighten tie-rod end nut with pushing ball stud to upper side so as not ball stud to be rotated.
^
For 4WD vehicle