Vitara 2WD V6-2.5L (2004)
8. Apply primer for molding (1) along molding surface all around as shown in the figure.
9. Apply adhesive (2) referring to the figure.
NOTE:
-
Start from bottom side of glass (3).
-
Be careful not to damage primer.
-
Height of adhesive (2) applied to lower side should be higher than that of other 3 sides.
Adhesive amount specification for windshield (upper, right and left sides)
Width "e": Approx. 11 mm (0.43 in.)
Height "f": Approx. 17 mm (0.67 in.)
Height "g": Approx. 25 mm (0.98 in.)
Distance "h": Approx. 16 mm (0.63 in.)
-
Press glass (3) against body quickly after adhesive (2) is applied.
-
Use of rubber sucker grip is helpful to hold and carry glass (3) after adhesive (2) is applied.
-
Perform Steps 9) to 10) within 10 min. to ensure sufficient adhesion.
-
Be sure to refer to adhesive maker's instruction for proper handling and drying time.