Vitara 4WD L4-2.0L (2003)
Liftgate Window Glass: Procedures
Back Door Glass Removal and Installation
Refer to "Windshield Removal and Installation: " procedures and cautions are basically the same. However, note the following.
-
Before applying primer to glass edge, install molding according to installing position shown in the figure.
Adhesive Amount Specification (Back Door Glass)
-
Observe the following precautions when applying adhesive along glass edge.
-
Adhesive should be applied evenly especially in height.
-
Be careful not to damage primer.
-
Press glass against body quickly after adhesive is applied.
Adhesive amount specification (back door glass)
Height "b": 15 mm (0.59 in.)
Width "c": 8 mm (0.31 in.)
Width "d": 16 mm (0.63 in.)
Clearance "e": 1 mm (0.04 in.)
-
When replacing back door, coat replacement door inside with wax for proper anticorrosive treatment. Refer to "Undercoating / Anti-Corrosion
Compound Application Area:".
-
Apply sealing compound to peripheral of door hem area and reinstall door sealing cover (1).
-
When weather-strip is hardened and water leaks have developed, replace it.
