Vitara 4WD L4-2.0L (2003)
2. Torque each bolt (2) and nut (1) to specification as indicated respectively in the figure.
Tightening torque
LSPV spring nut (a): 23 Nm (2.3 kgf-m, 17.0 ft. lbs.)
LSPV mounting bolt (a): 23 Nm (2.3 kgf-m, 17.0 ft. lbs.)
Brake pipe flare nut (b): 16 Nm (1.6 kgf-m, 11.5 ft. lbs.)
Air bleeding plug for LSPV (c): 7.5 Nm (0.75 kgf-m, 5.5 ft. lbs.)
3. Upon completion of installation, fill reservoir tank with specified fluid and bleed air from brake system.
NOTE: Make sure to bleed air from LSPV bleeder without failure.
4. After bleeding air, check that LSPV is installed properly.
