Vitara 4WD L4-2.0L (2003)
^
TP sensor coupler
^
EVAP canister purge valve coupler
^
Ground terminal from intake manifold
^
MAP sensor
6. Disconnect accelerator cable and A/T throttle cable (For A/T vehicle) from throttle body.
7. Disconnect the following hoses:
^
Brake booster hose from intake manifold
^
PCV hose from intake manifold
^
Fuel pressure regulator vacuum hose from intake manifold
^
Canister purge hose from EVAP canister purge valve
^
Vacuum hose from intake manifold
^
Water hoses from throttle body and water bypass pipe
^
Breather hose from throttle body
^
Fuel feed hose and return hose from each pipe
8. Remove fuel delivery pipe with fuel injectors from cylinder head.
9. Remove intake manifold front stiffener and rear stiffener.
10. Detach water pipe from intake manifold.
11. Remove intake manifold (1) from cylinder head, and then its gasket (2).
Installation
Reverse removal procedure for installation noting the followings.
^
Use new intake manifold gasket (1).
^
Install fuel delivery pipe with fuel injectors to cylinder head.
