Vitara 4WD L4-2.0L (2003)
2. Install water pump (1) by using new bolts (2) to cylinder block and tighten to specified torque.
NOTE: Use NEW bolts (total of 4) to install water pump to engine block. Failure to do so may result water leakage.
3. Install heater outlet pipe bolt (1).
4. Install generator belt.
5. Install radiator outlet hose to thermostat cap (2).
6. Refill cooling system with proper coolant .
7. Connect negative cable at battery.
Inspection
NOTE: Do not disassemble water pump. If any repair is required on pump, replace it as assembly.
1. Rotate water pump by hand to check for smooth operation. If pump does not rotate smoothly or makes abnormal noise, replace it.
