Vitara 4WD L4-2.0L (2003)
2. Install contact coil and combination switch assembly to steering column.
NOTE: New contact coil and combination switch assembly is supplied with contact coil set and held at its center position with a lock pin (2) and
seal (1). Remove this lock pin (2) after installing contact coil and combination switch assembly to steering column.
3. Connect all connectors that have been removed.
4. Install steering column upper cover (2) and lower cover (3), and then tighten steering column cover screws (1).
CAUTION: When installing lower cover (3) and upper cover (2), be careful so that contact coil and combination switch lead wire is not caught
between covers.
5. Install steering column hole cover (1).
6. Install steering wheel to steering column.
