Vitara 4WD L4-2.0L (2003)
4. Apply grease to "A" indicated in figure.
5. Position boot properly in grooves of gear case and tie-rod. Check to ensure that boot is free from twist and dent.
6. Fasten boot with new clamp and clip securely.
Special tool
(A): 09943-55010
7. Install tie-rod end lock nut and tie-rod end to tie-rod. Position lock nut to marking (1) made in removal.
NOTE: When tie-rod was replaced, measure length "A" on removed tie-rod and use it on new replacement tie rod so as to position lock nut
properly.
8. Install steering gear case.