Vitara 4WD L4-2.0L (2003)
Suspension Strut / Shock Absorber: Service and Repair
Removal and Install / Shock
Removal and Installation
NOTE: The shock absorber is non-adjustable, non-refillable, and cannot be disassembled. The only service the shock absorber requires is
replacement when it has lost its resistance, is damaged, or leaking fluid.
Removal
1. Hoist vehicle and remove rear wheel.
2. Support rear axle housing (1) by using floor jack (2) to prevent it from lowering.
3. Remove lock nut (7) (if equipped) and absorber nut (1).
4. Remove lower mounting bolt (6).
5. Remove shock absorber (5).
Installation
1. Install shock absorber. Refer to figure for proper installing direction of lower mounting bolt.
2. Remove floor jack.
3. Lower hoist.
4. Tighten nuts to specified torque.