Vitara 4WD L4-2.0L (2003)
19. For vehicle with ABS, tighten wheel speed sensor bolt to specified torque.
Tightening torque
Wheel speed sensor bolt (a): 21 Nm (2.1 kg-m, 15.5 ft. lbs.)
20. Connect brake pipes to wheel cylinders (right and left) and tighten brake pipe flare nuts to specified torque.
Tightening torque
Brake pipe flare nut (a): 16 Nm (1.6 kg-m, 11.5 ft. lbs.)
21. Install brake drum (right and left).
22. Refill differential gear housing with new specified gear oil.
23. Fill reservoir with brake fluid and bleed brake system.
24. Install wheel and tighten wheel nuts to specified torque.
Tightening torque
Wheel nut (a): 100 Nm (10.0 kg-m, 72.5 ft. lbs.)
25. Upon completion of all jobs, depress brake pedal with about 30 kg (66 lbs.) load three to ten times so as to obtain proper drum-to-shoe clearance.
Adjust parking brake cable.
26. Tighten parking brake lever cover screws.
27. Lower hoist.
28. Tighten right and left lower/upper rod nuts, lateral rod mount bolt and shock absorber lower nuts to specified torque.
NOTE: When tightening these nuts, be sure that vehicle is off hoist and in non-loaded condition.
29. Check to ensure that brake drum is free from dragging and proper braking is obtained.
30. Perform brake test (foot brake and parking brake).
31. Check each installed part for oil leakage.
