Vitara JLS (2Dr) 2WD L4-2.0L (2001)
_2wd/l4-2.0l/Page-945001.png)
Acceleration/Deceleration Sensor: Service and Repair
Type 1
REMOVAL
1. Turn ignition switch to OFF position and disconnect negative (-) cable from battery.
2. Remove rear center console box.
3. Remove parking brake lever bolts (Rear side) (3) and G sensor (2) with bracket from floor.
NOTE: Loosen only bolt (Front side) (4).
4. Remove sensor (2) with bracket from floor.
5. Disconnect connector from sensor (2).
CAUTION:
^
Do not separate sensor (2) and bracket (5). It will lead to erroneous assembly.
^
Sensor must not be dropped or shocked. It will affect its original performance.
INSPECTION
^
Check sensor bracket for bend.
