Vitara JLS (2Dr) 2WD L4-2.0L (2001)
2. Tighten wheel cylinder to brake back plate to specified torque.
3. Torque flare nut (or nuts) of brake pipe which was connected in step 1) to specification.
Tightening torque
Wheel cylinder bolt (for gasket sealed type) (a): 11 Nm (1.1 kg-m, 8.0 ft. lbs.)
Brake pipe flare nut (b): 16 Nm (1.6 kg-m, 12.0 ft. lbs.)
4. Install bleeder plug cap taken off from pipe back to bleeder plug.
5. For procedure hereafter, refer to steps 1) to 5) of BRAKE SHOE INSTALLATION.
NOTE: Be sure to bleed brake system.