Vitara JLS (2Dr) 2WD L4-2.0L (2001)
^
Check rotor serration (teeth) for being missing, damaged or deformed.
^
Turn wheel and check if rotor rotation is free from eccentricity and looseness
^
Check that no foreign material is attached.
If any faulty is found, repair or replace
INSTALLATION
1. Check that no foreign material is attached to sensor and rotor.
2. Install it by reversing removal procedure
Tightening torque
Rear wheel speed sensor bolt (a): 21 Nm (2.1 kg-m, 15.0 ft. lbs.)
CAUTION: Do not pull wire harness or twist more than necessary when installing rear wheel speed sensor.
3. Check that there is no clearance between sensor (1) and knuckle.
Rear Speed Sensor Ring/Rotor
REMOVAL
1. Remove rear axle shaft assembly.