Vitara JLS (2Dr) 2WD L4-2.0L (2001)
Camshaft Position Sensor: Service and Repair
CAUTION: Disassembly is prohibited. If anything faulty is found, replace as an assembly unit.
REMOVAL
1. Disconnect CMP sensor coupler (2).
2. Remove CMP sensor (1) by removing bolt(s) (3).
INSTALLATION
NOTE: After installing CMP sensor, adjust ignition timing. (Refer to "IGNITION TIMING CHECK AND ADJUSTMENT").
1. Install a new O-ring (2) with engine oil applied to CMP sensor (1).