Vitara JLS (2Dr) 2WD L4-2.0L (2001)
_2wd/l4-2.0l/Page-79006.png)
3. Disconnect front wheel speed sensor connector (1).
4. Remove harness clamp bolts (2) and remove front wheel speed sensor (1) from knuckle.
CAUTION:
^
Do not pull wire harness when removing front wheel speed sensor.
^
Do not cause damage to surface of front wheel speed sensor and do not allow dust, etc. to enter its installation hole.
INSPECTION
Sensor
^
Check sensor for damage. If any faulty is found, replace.
^
Check sensor for resistance. If any faulty is found, replace.
Resistance between terminals (Front wheel speed sensor): 1.2 - 1.6 k Ohms at 20°C (68°F)
Resistance between terminal and sensor body (Front wheel speed sensor): 1 M Ohms or more
Sensor Rotor
