Vitara JLS (2Dr) 2WD L4-2.0L (2001)
_2wd/l4-2.0l/Page-1125006.png)
12. Install O-ring (1) to pump body.
13. Apply power steering fluid to sliding surface of pump cover and rotor.
14. Match the dowel pins (1) to the holes of the cover plate (2) and install pump cover to pump body.
15. Gradually tighten new pump cover (1) bolts to specified torque.
NOTE: After installing pump cover, check to make sure that shaft can be turned by hand.
Tightening torque
Pump cover bolt (a): 23 Nm (2.3 kg-m, 17.0 ft. lbs.)
16. Apply power steering fluid to O-ring of pressure switch.
