Vitara JLS (2Dr) 2WD L4-2.0L (2001)
_2wd/l4-2.0l/Page-874009.png)
22. Fill reservoir with brake fluid and bleed brake system.
23. Install wheel and tighten wheel nuts to specified torque.
Tightening torque
Wheel nut (a): 100 Nm (10.0 kg-m, 72.5 ft. lbs.)
24. Upon completion of all jobs, depress brake pedal with about 30 kg (66 lbs) load three to ten times so as to obtain proper drum-to-shoe clearance.
Adjust parking brake cable.
25. Tighten parking brake lever cover screws.
26. Lower hoist.
27. Tighten right and left lower/upper rod nuts, lateral rod bolt and shock absorber lower nuts to specified torque.
NOTE: When tightening these nuts, be sure that vehicle is off hoist and in non-loaded condition.
Tightening torque
Lateral rod bolt (a): 90 Nm (9.0 kg-m, 65.0 ft. lbs.)
Lower rod nut (a): 90 Nm (9.0 kg-m, 65.0 ft. lbs.)
Upper rod nut (a): 90 Nm (9.0 kg-m, 65.0 ft. lbs.)
Shock absorber lower nut (b): 85 Nm (8.5 kg-m, 61.5 ft. lbs.)
28. Check to ensure that brake drum is free from dragging and proper braking is obtained.
29. Perform brake test (foot brake and parking brake).
30. Check each installed part for oil leakage.
