Vitara JLS (4Dr) 2WD L4-2.0L (2000)
_2wd/l4-2.0l/Page-692001.png)
Seals and Gaskets: Service and Repair
REMOVAL AND INSTALLATION
1. Lift vehicle horizontally.
2. Remove rear propeller shaft from extension case.
3. Pry shroud, felt and oil seal with flat-bladed tool.
4. Be sure to apply grease to oil seal lip. Using special tool and plastic hammer, press-fit new oil seal, felt and shroud up to position indicated in
figure.
"A": Grease 99000-25010
Special Tool
(A): 09940-53111
5. Install rear propeller shaft.
