Vitara JLS (4Dr) 2WD L4-2.0L (2000)
_2wd/l4-2.0l/Page-739008.png)
21. Refill differential gear housing with new specified gear oil. Refer to Differential.
22. Fill reservoir with brake fluid and bleed brake system.(For bleeding operation, Brakes and Traction Control)
23. Install wheel and tighten wheel nuts to specified torque.
Tightening Torque (h): 95 Nm (9.5 kg-m, 69.0 ft. lbs.)
24. Upon completion of all jobs, depress brake pedal with about 30 kg (66 lbs.) load three to ten times so as to obtain proper drum-to-shoe
clearance. Adjust parking brake cable (for adjustment, see Brakes and Traction Control.)
25. Tighten parking brake lever cover screws.
26. Lower hoist.
27. Tighten right and left lower/upper rod nuts lateral rod mount bolt and shock absorber nuts to specified torque.
NOTE: When tightening these nuts, be sure that vehicle is off hoist and in non loaded condition.
Tightening Torque
(i): 90 Nm (9.0 kg-m, 65.0 ft. lbs.)
(j): 85 Nm (8.5 kg-m, 61.5 ft. lbs.)
28. Check to ensure that brake drum is free from dragging and proper braking is obtained.
29. Perform brake test (foot brake and parking brake).
30. Check each installed part for oil leakage.
