Vitara JLX (2Dr) 4WD L4-2.0L (2001)
_4wd/l4-2.0l/Page-857002.png)
Reverse removal sequence noting the following points.
^
Tighten clutch fluid pipe flare nuts (3) to specified torque.
Tightening torque
Clutch fluid pipe flare nut (a) 16 Nm (1.6 kg-m, 11.5 ft. lbs.)
^
For air bleeding of master cylinder alone, it must be removed from vehicle.
(For procedures of removal and installation of master cylinder assembly and air bleeding, refer to "CLUTCH MASTER CYLINDER".)
^
Do not allow fluid to get on painted surface.
^
Do not allow pipe (1) and hose (2) to contact hard against vehicle or other parts.
^
Install each clamp securely.
^
Install E-ring (4) securely as shown in the figure.
^
After installation, check clutch pedal free travel and bleed air from system.
^
Check fluid leakage.
^
Add fluid close to MAX level of reservoir.
