Vitara JLX (2Dr) 4WD L4-2.0L (2001)
_4wd/l4-2.0l/Page-882004.png)
14. Remove stud bolt(s) (1) by using hydraulic press (2).
INSTALLATION
Install removed parts in reverse order of removal procedure, noting the following.
Apply grease "A" to oil seal lip (2) of bearing retainer (1) and install it to axle shaft.
NOTE: A mount of grease applied to hollow in oil seal should be more than 60% of its vacant space.
"A": Grease 99000-25010
15. Aligning serrations between new stud bolt(s) (1) and flange (4), install new stud bolt(s) (1) by tightening nut (2).
