Vitara JLX (2Dr) 4WD L4-2.0L (2001)
3. If control lever locating bolts (1) are replaced or retightened, torque them as specified.
Replacing of control lever locating bolts (1) requires thread lock cement.
"B" : Cement 99000-32020
Tightening torque
Control lever locating bolt (a) 17 Nm (1.7 kg-m, 12.5 ft. lbs.)
4. Apply grease to pivot portions and seat, then install shift control lever.
"A": Grease 99000-25010
5. Install transmission boot No. 1 (1) from inside of cabin and clamp it with a new clamp (2) securely.
6. Install transfer boot No. 1 (1) securely on lift and clamp it by using a new clamp (2).
7. Tighten transmission boot No. 2 (2) with boot cover and console box bracket (1).
Tightening torque
Control lever boot cover bolt (a) 6 Nm (0.6 kg-m, 4.0 ft. lbs.)
8. Install console box.