Vitara JLX (4Dr) 4WD L4-2.0L (2000)
_4wd/l4-2.0l/Page-1290001.png)
Brake Switch (Cruise Control): Testing and Inspection
STOP LAMP SWITCH (WITH PEDAL POSITION SWITCH) INSPECTION
1. Disconnect negative cable (-) at battery.
2. Disconnect stop lamp switch connector and remove stop lamp switch from pedal bracket.
3. Check switch (two contacts) for resistance under each of the conditions shown.
If check result is not satisfactory, replace stop lamp switch.
4. Install stop lamp switch and adjust its position.
