Vitara JLX (4Dr) 4WD L4-2.0L (2000)
_4wd/l4-2.0l/Page-286006.png)
2. Install valve lash adjusters to cylinder head.
Apply engine oil around valve lash adjuster and then install it to cylinder head.
3. Match key on crankshaft to timing mark as shown in figure.
4. Install camshafts.
Apply oil to sliding surface of each camshaft and camshaft journal then install them by aligning match marks on cylinder head and pins on
camshafts as shown in figure.
NOTE: Install camshaft in such direction that its end with groove for CMP sensor installation comes to exhaust side.
5. Install camshaft housing pins as shown in figure.
6. Apply sealant "A" to exhaust camshaft end housing sealing surface area as shown in figure.
"A": Sealant 99000-31150
