Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
5) Tighten brake back plate nuts to specified torque.
Tightening Torque (a): 23 Nm (2.3 kg-m, 17.0 ft. lbs.)
6) Install wheel cylinder, and tighten wheel cylinder bolts and brake pipe flare nut (or nuts) to specified torque.
7) Install parking brake cable to brake back plate.
8) Install brake shoes, referring to steps 1) and 4) of Brake Shoe; Service and Repair.
9) Install brake drum. Refer to steps 1) to 2) of Brake Drum; Service and Repair.
10) Refill differential housing with new specified gear oil.
11) Fill reservoir with brake fluid and bleed brake system. See: Brake Bleeding
12) Install wheel and tighten wheel nuts to specified torque.
Tightening Torque (b): 95 Nm (9.5 kg-m, 69.0 ft. lbs.)
13) Upon completion of all jobs, depress brake pedal with about 30 kg (66 lbs) load three to ten times so as to obtain proper drum to shoe clearance.
Adjust parking brake cable.
14) Tighten parking brake lever cover screws.
15) Check to ensure that brake drum is free from dragging and proper braking is obtained. Then remove vehicle from hoist and perform brake test
(foot brake and parking brake).
16) Check each installed part for oil leakage.