Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
_2wd/l4-1.6l_dohc_mfi/Page-1125004.png)
8) Repeat steps 5) through 7) for right front brake, and then left front brake according to instruction of scan tool.
9) Bleed again from each bleeder plug (screw) independently for approximately 20 seconds in the same way as steps 5), 6) and 7) according to
instruction of scan tool ((vi), (vii) and (viii)).
This step should allow any remaining air to be purged from brake lines.
10) When automated bleed procedure is completed, scan tool will display the appropriate message (ix).
Remove pressure bleeding tool from reservoir tank (if installed).
11) After completing bleeding operation, apply fluid pressure to pipe line and check for leakage.
12) Replenish fluid into reservoir up to specified level.
13) Check brake pedal for "sponginess". If found spongy, repeat entire procedure of bleeding.
