Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
4) Remove bolt and take out ABS actuator (EBCM & BPMV) assembly from bracket.
CAUTION:
^
Do not give an impact to ABS actuator (EBCM & BPMV) assembly.
^
Use care not to allow dust to enter ABS actuator (EBCM & BPMV) assembly.
^
Do not place hydraulic unit on its side or upside down. Handling it in inappropriate way will affect its original performance.
INSTALLATION
1) Install ABS actuator (EBCM & BPMV) assembly by reversing removal procedure.
Tightening Torque
(a): 16 Nm (1.6 kg-m, 12.0 ft. lbs.)
(b): 23 Nm (2.3 kg-m, 17.0 ft. lbs.)
(c): 10 Nm (1.0 kg-m, 7.5 ft. lbs.)
2) Bleed air from brake system. See: Brake Bleeding
3) Check each installed part for fluid leakage and perform ABS actuator (EBCM & BPMV) assembly operation check.