Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
1. Install magnet clutch coil.
Protrusion on under side of coil ring must match hole in compressor assembly to prevent movement ant correctly locate lead wire.
2. Using special tool (C), install snap ring as shown.
Special Tool
(C): 09990-06107
3. Install clamp portion and ground terminal of lead wire.
4. Install magnet clutch.
1. Set magnet clutch squarely over clutch installation boss.
2. Place special tool (D) onto clutch bearing.
Ensure that edge rests only on inner race of bearing.
3. Install snap ring.
Special Tool
(D): 09991-06010
CAUTION: Be careful not to scratch bearing seal.