Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
Sensing and Diagnostic Module: Service and Repair
Removal and Installation
WARNING: During service procedures, be very careful when handling a Sensing and Diagnostic Module (SDM). Be sure to read "Service
Precautions" in this section before starting to work and observe every precaution during work. Neglecting them may result in personal injury
or inactivation of the air bag system when necessary.
REMOVAL
1. Disconnect negative cable at battery.
2. Disable air bag system. Refer to "Air Bag(s) Arming and Disarming".
3. Remove rear and front center console box by removing screw and clips.
4. Remove center garnish panel.
5. Remove ashtray and tuner assembly, clock assembly, tuner pocket, radio hole cover, etc.