Front Wheel Speed Sensor Service and Repair | Vitara JS (2Dr) 2WD L4-16L DOHC MFI (1999)
_2wd/l4-1.6l_dohc_mfi/Page-75001.png)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor
REMOVAL
1) Disconnect negative cable from battery.
2) Hoist vehicle.
3) Disconnect rear wheel speed sensor connector and detach wire harness from vehicle body and rear axle.
4) Remove harness clamps and remove rear wheel speed sensor from rear axle.
CAUTION:
^
Do not pull wire harness when removing rear wheel speed sensor.
^
Do not cause damage to surface of rear wheel speed sensor and do not allow dust, etc. to enter its installation hole.
SENSOR INSPECTION
^
Check sensor (pole piece) for damage or bent.
^
Check sensor for resistance.
Resistance between terminals 0.8 - 1.6 K ohms at 20°C, 68°F
Resistance between terminal and sensor body: 1 M ohms or more
If any faulty is found, replace.
SENSOR ROTOR INSPECTION