Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
_2wd/l4-1.6l_dohc_mfi/Page-1268004.png)
^
When installing circlip to drive shaft, utilize screw hole in drive shaft to pull it out and bring large diameter of circlip at right as shown.
^
When installing axle shaft drive flange to wheel hub, apply sealant to mating surface of axle shaft drive flange and tighten flange bolt to
specified torque.
"A": Sealant 99000-31090
Tightening Torque (a): 48 Nm (4.8 kg-m, 35.0 ft. lbs.)
^
Check that no foreign material is attached to sensor and rotor. Install wheel speed sensor and its harness clamp.
Tightening Torque
(a): 10 Nm (1.0 kg-m, 7.5 ft. lbs.)
(b): 23 Nm (2.3 kg-m, 17.0 ft. lbs.)
CAUTION:
^
Do not pull wire harness or twist more than necessary when installing front wheel speed sensor.
^
Fit harness grommet to inner fender securely.
^
Check that there is no clearance between sensor and knuckle.
