Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
_2wd/l4-1.6l_dohc_mfi/Page-971002.png)
2) Connect inner end of interlock cable to key interlock lever (Ignition switch side).
3) Install outer end bracket of interlock cable to ignition switch assembly, and tighten screw to specified torque.
Tightening Torque (a): 2.2 Nm (0.22 kg-m, 1.5 ft. lbs.)
4) Pass and connect interlock cable as shown in the figure.
TYPE-1
5) Fix interlock cam by inserting pin with about 4 mm (0.15 inch) diam. into holes of cam and lever plate.
6) Install cable end to interlock cam and stud bolt and after making sure that cable outer is pushed in arrow direction B by leaf spring, tighten
mounting nut to specified torque. Remove pin.
