Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
Shift Cable: Adjustments
SELECT CABLE
ADJUSTMENT
1) Before tightening cable end nut, shift select lever to "N".
2) Also shift manual shift lever to "N".
NOTE:
^
Make sure that nut and cable joint have clearance under above conditions.
^
If select cable has been moved, push it in arrow C direction as shown in figure at the left till it stops and then confirm that select lever is in "N"
position.
3) Turn nut A by hand till it contacts manual select cable joint.
Then tighten nut B with wrench.
4) After select cable was installed, check for the following.
^
Push vehicle with select lever shifted to "P". Vehicle should not move.
^
Vehicle can not be driven in "N".
^
Vehicle can be driven in "D", "2", and "L".
^
Vehicle can be backed in "R".