Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
Shifter A/T: Service and Repair
MANUAL SELECTOR ASSEMBLY
REMOVAL
1) Disconnect negative cable at battery.
2) Remove console box.
3) Disconnect connector for illumination lamp, shift lock solenoid and overdrive OFF switch.
4) Disconnect interlock cable from interlock cam of selector assembly.
5) Remove selector assembly mounting bolts.
6) Disconnect select cable from lever of selector assembly.
INSTALLATION
NOTE: New selector assembly of Type-1 is supplied with held interlock cam at interlock cable connecting position with pin. Remove this pin after
connecting interlock cable to interlock cam and tightening cable nut.
Reverse removal procedure to install noting the followings.
^
Connect interlock cable end to cam referring to steps 2) to 8) of "Interlock Cable Installation".
^
Upon completion of installation, confirm that brake (key) interlock system operates properly.