Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
_2wd/l4-1.6l_dohc_mfi/Page-1009005.png)
3) Install lateral rod to rear axle housing.
4) Install lower part of shock absorber to right and left sides of axle housing and install bolts in proper direction as shown in figure. At this time,
mount nuts but don't tighten them.
5) Clean mating surfaces of axle housing and differential carrier and apply sealant to housing side.
"A": Sealant 99000-31110
6) Install differential carrier assembly to axle housing and tighten carrier nuts to specified torque.
Tightening Torque (a): 55 Nm (5.5 kg-m, 40.0 ft. lbs.)
7) For vehicle with ABS, connect wheel speed sensor coupler and install harness.
8) Install propeller shaft and torque nuts to specification.
Tightening Torque (b): 50 Nm (5.0 kg-m, 36.5 ft. lbs.)
