Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
_2wd/l4-1.6l_dohc_mfi/Page-1009006.png)
9) Remove floor jack from axle housing and connect breather hose onto axle housing and clamp it securely.
10) Connect brake pipes onto axle housing and clamp them securely.
11) Connect brake flexible hose to bracket on axle housing and secure it with E-ring.
12) Install LSPV stay to axle housing, tighten LSPV stay bolt to specified torque.
And adjust LSPV referring to LSPV ASSEMBLY ADJUSTMENT.
Tightening Torque (c): 23 Nm (2.3 kg-m, 17.0 ft. lbs.)
13) Connect brake pipe to brake flexible hose and tighten brake pipe flare nut to specified torque.
Tightening Torque (d): 16 Nm (1.6 kg-m, 11.5 ft. lbs.)
14) Clean mating surface of axle housing (right & left) and brake back plate, then apply sealant as shown.
"A": Sealant 99000-31110
15) Apply grease to axle shaft inner oil seal lip as shown.
"A": Grease 99000-25010
