Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
8. Remove door outside weather-strip (1).
Lower window all the way down. Then, use a tape-wrapped putty knife (or screwdriver) to pry off weather-strip.
CAUTION: Use a tape-wrapped putty knife (or screwdriver) to pry off weather-strip. Use of an unwrapped tool will cause damage to painting.
9. Remove glass attaching screws (1).
10. Take out door glass.
Installation
Reverse removal procedure to install door glass noting the following points:
^
Tighten glass attaching screws (1) to specified torque. Tighten front screw first, then rear screw.
Tightening Torque
Glass attaching screw (front and rear) (a): 2.5 Nm (0.25 kg-m, 1.8 ft. lbs.)
^
When window becomes hard to raise and lower, adjust screws (1) to correct tilted glass as shown in the figure.