Vitara JS (4Dr) 2WD L4-2.0L (2000)
Brake Fluid: Testing and Inspection
Fluid Pressure Test
FLUID PRESSURE TEST (if equipped with LSPV)
Test procedure for LSPV assembly is as follows.
Before testing, confirm the following.
^
Fuel tank is filled with fuel fully.
^
Vehicle is equipped with spare tire, tools, jack and jack handle.
1. Stop vehicle on level floor and place approximately about 200 kg (441 lbs.) weight on rear housing so that rear axle weighs 800 kg (1764 lbs.).
Rear axle weight "L": 800 kg (1764 lbs.)
2. Install special tool to front and rear brake.
NOTE: Special tool should be connected to breather of front (driver's side brake) and rear brakes.
Special Tool
Front brake
(A): 09956-02310
(B): 09952-46510 (Attachment for vehicle with H25 engine)
(C): 55473-82030 (Air bleeder plug supplied as a spare part)
Rear brake
(A): 09956-02310
(B): 09952-36310
(C): 55473-82030 (Air bleeder plug supplied as a spare part)
NOTE: Special tool (B) is used instead of thread diameter 10 mm attachment of special tool (A). So remove the attachment from (A) and install
(B) as shown in figure.
For vehicle with other than H25 engine, use the attachment included in special tool (A).