Vitara JS (4Dr) 2WD L4-2.0L (2000)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Type 2
HYDRAULIC UNIT INSPECTION
Check hydraulic unit for fluid leakage. If any, repair or replace.
REMOVAL
1. Disconnect negative cable from battery.
2. Using special tool, disconnect brake pipes from ABS hydraulic unit/control module assembly and loosen flare nuts as shown figure.
Special Tool
(A): 09950-78220
NOTE: Put bleeder plug cap onto pipe to prevent fluid from spilling. Do not allow brake fluid to get on painted surfaces.
3. Disconnect ABS hydraulic unit/control module assembly connector.