Vitara JS (4Dr) 2WD L4-2.0L (2000)
Coolant Line/Hose: Service and Repair
COOLING WATER PIPES OR HOSES
[G16 and J20 engines]
REMOVAL
1. Drain cooling system.
2. To remove these pipes or hoses, loosen screw on each pipe or hose clip and pull hose end off.
INSTALLATION
Install removed parts in reverse order of removal procedure, noting the following.
^
Tighten each clamp bolt securely.
^
When installing water outlet pipe to cylinder head, apply sealant to pipe bolt thread and then tighten it (J20 engine only).
Sealant "A": 99000-31110 (SUZUKI BOND No.1215.)
^
Refill cooling system with proper coolant, referring to description on "COOLANT" and steps 8. to 10. of "COOLING SYSTEM FLUSH AND
REFILL" located under Cooling System.
^
Check each part for leakage.
[H25 engine]
REMOVAL
1. Disconnect negative cable at battery.
2. Drain coolant.
3. Remove radiator inlet, outlet hoses and radiator outlet pipe.
4. Remove throttle body and intake manifold. Refer to Fuel Delivery and Air Induction.
5. Disconnect coolant temperature sensor (ECT sensor) coupler.
6. Disconnect heater inlet hose from water outlet cap.