Vitara JS (4Dr) 2WD L4-2.0L (2000)
6. BRUSH HOLDER
-
Check movement of brush in brush holder. If brush movement within brush holder is sluggish, check brush holder for distortion and sliding
faces for contamination. Clean or correct as necessary.
-
Check for continuity across brush positive terminal and grounded brush holder. If continuity exists, brush holder is grounded due to defective
insulation and should be replaced.
7. ARMATURE
-
Inspect commutator for dirt or burn. Correct with sandpaper or lathe, if necessary.
-
Check commutator for uneven wear with armature supported on V-blocks. If deflection of dial gauge pointer exceeds limit, repair or replace.
NOTE: Below specification presupposes that armature is free from bend. Bent armature must be replaced.
Commutator out of round
Standard: 0.05 mm (0.002 in.) or less