Vitara JX (4Dr) 4WD L4-2.0L (2000)
Load Compensator: Service and Repair
REMOVAL
1. Clean around reservoir cap and take out fluid with syringe or such.
2. Hoist vehicle.
3. Disconnect brake pipes from LSPV.
4. Remove LSPV assembly from vehicle body.
NOTE: As shown in the image, LSPV assembly should be removed together with its spring and stay installed or rear axle housing.
5. Remove spring and stay from lever.
CAUTION: LSPV assembly must not be disassembled. Replace with new one if defective.
INSTALLATION
CAUTION: Refer to above CAUTION.