Vitara JX (4Dr) 4WD L4-2.0L (2000)
7. Remove water outlet cap from cylinder heads.
8. Remove water outlet pipe from thermostat case.
9. Remove thermostat case from cylinder block.
INSTALLATION
Install removed parts in reverse order of removal procedure, noting the following.
1. Install thermostat case to cylinder block with new O-ring.
2. Install water outlet pipe to thermostat case with new O-rings.
3. Install water outlet cap to cylinder heads with new gaskets.
4. Connect heater hose to water outlet cap.
5. Connect ECT sensor coupler.
6. Install throttle body and intake manifold. Refer to Fuel Delivery and Air Induction.
7. Install radiator outlet pipe to thermostat case with new O-ring.
8. Install radiator inlet and outlet hoses.
9. Refill cooling system with proper coolant, referring to description on "COOLANT" and steps 8. to 10. of "COOLING SYSTEM FLUSH AND
REFILL" located under Cooling System.