Vitara JX (4Dr) 4WD L4-2.0L (2000)
Tie Rod End: Service and Repair
REMOVAL
1. Jack up vehicle and remove wheel.
2. Remove tie-rod end nut.
3. Disconnect tie-rod end by using puller.
4. To facilitate adjustment after installation, put a mark on tie-rod thread indicating position of tie-rod end lock nut. Then loosen lock nut and remove
tie rod end from tie rod.
INSPECTION
Tie-rod End Ball Joint
Inspect for play in tie-rod end ball joint. If found defective, replace.
INSTALLATION