X-90 (2WD) L4-1591cc 1.6L SOHC MFI (1997)
/l4-1591cc_1.6l_sohc_mfi/Page-1024005.png)
6. Install snap ring to shaft.
7. Tighten cover bolts to specified torque.
NOTE: After installing cover, check to make sure that shaft can be turned by hand.
Tightening Torque (a): 20 Nm (14.5 ft. lbs.)
8. Check that flow control valve slides smoothly and tighten discharge (delivery) connector to specified torque.
Tightening Torque (b): 50 Nm (36.5 ft. lbs.)
9. Tighten power steering pressure switch (terminal set) to specified torque.
Tightening Torque (c): 28 Nm (20.5 ft. lbs.)
