X-90 (2WD) L4-1591cc 1.6L SOHC MFI (1997)
/l4-1591cc_1.6l_sohc_mfi/Page-803002.png)
3. Check gear shift shaft for excessive wear and correct or replace as necessary.
4. Check free length of each locating spring and replace if it is below service limit.
Free length:
Standard: 27.0 mm (1.063 inch)
Service limit: 24.0 mm (0.945 inch)
ASSEMBLY
Interlock system is as shown in the figure.
Assemble its parts according to procedure as described.
(1) Locating ball
(2) Rubber plug
(3) Reverse gear shift shaft
(4) Interlock ball
(5) Interlock pin
(6) High speed gear shift shaft
(7) Low speed gear shift shaft
1. With fork installed to reverse gear shift shaft (1), install it into case and put in interlock ball (2).
NOTE:
